Installation Instruction

The installation of STYX watch protection film is not as complicated as you might think. Follow the instructions in the video and your watches will be protected with STYX in just 30 minutes

Clean watch surface thoroughly with alcohol wipe , then repeat with alcohol wipe

Using the provided tweezers, remove a piece of watch protection film from its backing, then immerse in water. 

Adjust the film until it is perfectly aligned with the corresponding watch component.

Remove any excess moisture trapped under the film, then wait one minute for the film to achieve complete adhesion.

Repeat steps 2-4 with the remaining film.

After installation, clean timepiece with the provided microfiber towel.

Any residue moisture on or under the film will dissipate within 24- 48 hours.